8/8/2023 0 Comments Railroad track anvil hook![]() ![]() If your very polite and explains what your trying to do most Peaple will help, if not be polite and walk away. So, for lift repair shops, tractor repaoir shops, earthmoving equipment shops, tractor/trailer (over the road trucks) shops, train repair shops, train track repair yards, industrial fabrication shops (welding shops making big stuff) or the scrap yards the sell to are all places to ask for help. So, with the above examples in mind, look for a large piece of steel, Be it a large shaft, block, or even a large drop from cutting a large round plate out of a square piece of stock. And that little block has a few advantages as well, if you radius each edge differently you have built in fullers, each face can also be modified to be swage.Īs for needing a horn, any piece of large round can be used as a bick, and as you get the skills you can forge it out to form a traditional bick. If you do resort to stone I recommend a hard if jus stone (granite or basalt) and of large size (the cast ASO might look good at that point)Īs Thomas Powers will no doubly point out a 4" square block of iron was an anvil for most of the history of iron. Things I'd avoid, I beam, steel plate (unless its 2+ inch thick then set it on end) cast iron anything. ![]() There is a member with rock crusher parts I think you get the idea. Heavy gage rail works, again set it on end. But let me see what I can do to guid you to a usable piece of steel.Ī 20# slege hammer head will work, mount it with one face up, any peice of 2+ inch peice of solid stock, 4x4 being my preference set on end. There are plenty of posts concerning "improvised" anvils, knife makes anvils ant "y1k" anvils.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |